HP ProLiant DL380 Server - Manual (Page 64)

Hardware options installation 64
6. Remove the expansion slot blank.
To replace the component, reverse the removal procedure.
Installing a full-length expansion board
1. Power down the server (on page 21 ).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 21 ).
4. Remove the access panel (on page 22 ).
5. Release the full-length expansion board retainer, and then remove the PCI riser cage.
6. Remove the expansion slot cover (" Removing the expansion slot blanks " on page 63 ).
7. Install the expansion board.