HP ProLiant DL380 Server - Manual (Page 60)

Hardware options installation 60
7. Connect the power and data cable to the system board and the optical drive.
8. Install the access panel (on page 23 ).
9. Install the server into the rack (" Installing the server into the rack " on page 35 ).
10. Connect each power cord to the server.
11. Connect each power cord to the power source.
12. Power up the server (on page 21 ).
Redundant hot-plug power supply option
CAUTION: All power supplies installed in the server must have the same output power capacity.
Verify that all power supplies have the same part number and label color. The system becomes
unstable and may shut down when it detects mismatched power supplies.
Label color Output
Blue 460W
Orange 750W
White
750W 48V DC
Green 1,200W
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To install the component:
1. Access the product rear panel (on page 23 ).
2. Remove the blank.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.