HP StoreEver Ultrium Tape Drives - Manual (Page 23)

Figure 4 Removing cover from ProLiant ML370 server
1. Release catch
2. Push cover back and lift off
4. Remove the filler panel from a spare 5¼-inch bay of your server, as described in your server’s
documentation. With some servers, such as the HP AlphaServer ES40, you must also remove the
half-height device divider.
5. You are now ready to install your tape drive.
Attach mounting hardware
If your server requires special rails or other hardware to install the tape drive, mount them on the tape
drive now.
If your server does not require special mounting hardware, proceed to
Install drive now.
CAUTION:
The Ultrium half-height drive only allows 3 mm of the engagement of the screw into the drive. If you
remove an existing drive, do not assume the screws that you remove are the correct length for your new
Ultrium drive. Always use the screws supplied with your Ultrium drive.
HP ProLiant servers
NOTE:
If mounting hardware is supplied with your tape drive, it may not be exactly the same as shown in
the illustrations.
Different models of server require different mounting methods. The server may also incorporate a locking
mechanism to hold the tape drive in place. See Secure the drive .
Ultrium full-height SCSI Tape Drives 23