Common configuration tasks, Setting up gwlm (initial setup steps) – HP Matrix Operating Environment Software User Manual
Page 21
Resizing a workload’s npar, vpar, virtual machine, pset, or fss group as needed
To ensure a workload gets the CPU resources it needs—while also allowing resource sharing
when possible—gWLM provides OwnBorrow policies.
With such a policy, you indicate the amount of CPU resources a workload should own. The
workload is then allocated this owned amount of CPU resources—when it needs it. However,
you can configure the workload to:
•
Lend CPU resources to other workloads when it is idle
•
Borrow CPU resources from workloads that are idle
Associate an OwnBorrow policy with a workload:
•
When creating an SRD, as described in
“Getting started with gWLM” (page 17)
•
When adding a workload to an SRD, as described in
“Adding a new compartment or GiCAP
group member to an SRD” (page 24)
•
By changing the policy associated with an existing workload, as described in
which policy is associated with a workload” (page 23)
gWLM’s utilization policies also allow resizing.
Common configuration tasks
This section discusses various configuration tasks:
•
“Changing from advisory mode to managed mode” (page 22)
•
“Creating a new policy” (page 22)
•
•
“Changing which policy is associated with a workload” (page 23)
•
“Adding a new compartment or GiCAP group member to an SRD” (page 24)
•
“Stop managing a workload” (page 24)
•
“Stop managing an SRD” (page 25)
Setting up gWLM (initial setup steps)
Several of the configuration tasks require the same initial set-up steps. (Each task requiring these
steps indicates that the steps are needed.) These steps are given below.
NOTE:
You must be logged in as root on the systems where you run the gwlmagent command
mentioned below.
1.
Configure your CMS as indicated in the VSE Management Software Installation and Update
Guide, if you have not already done so.
2.
On each managed node, start the gWLM agent (if it is not already running):
# /opt/gwlm/bin/gwlmagent
Alternatively, you can start the agents through HP SIM, as discussed in the VSE Management
Software Installation and Update Guide.
Common configuration tasks
21