Acura 2010 RDX - Manual (Page 75)

If this indicator blinks while driving,
it indicates the differential
temperature is too high.
You will also see an ‘‘SH-AWD DIFF
TEMP. HIGH ’’ message on the multi-
information display (see page 80 ).
Pull to the side of the road when it is
safe, shift to Park, and let the engine
idle until the indicator goes out. If
the indicator does not go out, take
your vehicle to a dealer to have it
checked.
For more information, see page 385 .
Continuing to drive with the SH-AWD
indicator blinking may cause serious
damage to the system.
Low Tire Pressure/TPMS
Indicator
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position.
This indicator has two functions:
1. If it comes on while driving, it
indicates that one or more of your
vehicle's tires are significantly low
on pressure.
You will also see a ‘‘CHECK TIRE
PRESSURE ’’ message on the multi-
information display (see page 79 ).
Check the tire pressure monitor on
the multi-information display and
determine the cause (see page
392 ).
If this happens, pull to the side of the
road when it is safe, check which tire
has lost pressure on the multi-
information display, and determine
the cause. If it is because of a flat tire,
have the flat tire repaired as soon as
possible. If two or more tires are
underinflated, call a professional
towing service. For more
information, see page
475 .
CONTINUED
Instrument Panel Indicators
71
Instruments
and
Controls
09/07/07 15:02:04 10 ACURA RDX MMC North America Owner's M 50 31STK630 enu
2010 RDX