Acura 2010 RDX - Manual (Page 73)

VSA Activation Indicator
This indicator has three functions:
1. It comes on as a reminder that you
have turned off the vehicle stability
assist (VSA) system.
2. It flashes when VSA is active (see
page 395 ).
3. It comes on along with the VSA
system indicator if there is a
problem with the VSA system.
You will also see a
‘‘CHECK VSA
SYSTEM ’’ message on the multi-
information display (see page 80 ).
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. For more information, see
page
395 .
Cruise Main Indicator
This indicator comes on when you
turn on the cruise control system by
pressing the CRUISE button (see
page
300 ).
Cruise Control Indicator
This indicator comes on when you
set the cruise control. See page
300
for information on operating the
cruise control.
High Beam Indicator
This indicator comes on with the
high beam headlights. For more
information, see page
117.
This indicator also comes on with
reduced brightness when the
daytime running lights (DRL) are on
(see page
119 ).
Turn Signal and Hazard Warning
Indicators
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is burned
out (see pages
432 and 434 ). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle flash.
CONTINUED
Instrument Panel Indicators
69
Instruments
and
Controls
09/07/07 15:02:04 10 ACURA RDX MMC North America Owner's M 50 31STK630 enu
2010 RDX