Acura 2010 RDX - Manual (Page 438)

5. Turn on the lights to make sure
the new bulb is working.
6. Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
7. Reinstall the light assembly cover.
Replacing Rear Bulbs
(in Rear Pillar)
1. Open the tailgate.
2. Remove the two bolt covers on the
rear pillar by prying on the bottom
edge with a flat-tip screwdriver.
Remove the bolts with a Phillips-
head screwdriver, and remove the
light assembly from the rear pillar.
3. Determine which of the three
bulbs is burned out: brake/
taillight, turn signal or rear side
marker.
4. Remove the socket by turning it
one-quarter turn counterclockwise.
5. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
COVERS
BOLTS
BULB SOCKET
Lights
434
09/07/07 15:02:04 10 ACURA RDX MMC North America Owner's M 50 31STK630 enu
2010 RDX