beautypg.com

Seat heaters, 2010 rdx – Acura 2010 RDX User Manual

Page 145

background image

Both front seats are equipped with
seat heaters. The passenger seat is
only heated in the seat bottom
because of the side airbag cutoff
system.

The ignition switch must be in the
ON (II) position to use seat heaters.
Push the top of the switch, HI, to
rapidly heat up the seat. After the
seat reaches a comfortable
temperature, select LO by pushing
the bottom of the switch. This will
keep the seat warm.

In the HI setting, the heater turns off
when the seat gets warm, and turns
back on after the seat's temperature
drops.

In the LO setting, the heater runs
continuously. It does not cycle with
temperature changes.

Follow these precautions whenever
you use the seat heaters:

Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current from the
battery.

If the engine is left idling for an
extended period, do not use the
seat heaters, even on the LO
setting. It can weaken the battery,
causing hard starting.

Passenger's Seat

HEATERS

Driver's Seat

SEAT HEATER SWITCHES

Seat Heaters

141

Instruments

and

Controls

09/07/07 15:02:04 10 ACURA RDX MMC North America Owner's M 50 31STK630 enu

2010 RDX

This manual is related to the following products: