Actiontec electronic GT701R - Manual (Page 61)

56
Actiontec USB/Ethernet DSL Modem User Manual
57
Chapter 8 Troubleshooting
There should be an entry for IP address, Subnet Mask, and Default Gateway.
Additionally, the “ IP Address” entry should be on the 192.168.0. X network
(with “ X ” defining a range from 2 though 255).
If the Ethernet adapter is showing an incorrect IP address, click Release, which
sets all values back to 0 (zero). Then, click Renew (this process may take a few
seconds). The renewed
IP address should be on the 192.168.0. X network.
If an error occurs, or the IP address renews with an address outside the
192.168.0. X network, contact the ISP immediately
s
If running Windows 98 SE or Me, check the computer’s TCP / IP settings. Select
Start, Run, enter
CMD
in the “Open” text box, then press OK. A “ DOS ” window appears, with a blink-
ing cursor (prompt). Enter
ipconfig
at the prompt, then press Enter on the keyboard.
The
IP address of the Ethernet adapter should appear in the DOS window.
Ensure the IP address is on the 192.168.0. X network (with “ X ” defining a
range from 2 though 255).
If the Ethernet adapter is showing an incorrect
IP address, enter
ipconfig /release
at the prompt (note the space before the forward slash), then press Enter
on the keyboard, which sets all values back to 0 (zero). Next, enter
ipconfig /renew
at the prompt (note the space before the forward slash), then press Enter
on the keyboard (this process may take a few seconds). The renewed
IP address
should be on the 192.168.0. X network.
If an error occurs, or the IP address renews with an address outside the
192.168.0. X network, contact the ISP immediately.
s
Ensure the browser is not set to “Never dial a connection” and there are no
previous LAN settings.
To check this, go to Start, Settings, Control Panel. In the Control Panel,
double-click Internet Options. When the “Internet Properties” window
appears, ensure the “Never dial a connection” option is not activated, then
click
LAN Settings. When the “Local Area Network ( LAN ) Settings” window
appears, ensure no settings are activated. If there are settings activated, deac-
tivate them.
s
Shutdown and restart the computer. After the computer restarts, unplug
the Power cord from the Modem and plug it back in. When the Power and
Internet lights glow solid green, try accessing the Internet.