Actiontec electronic GT701R - Manual (Page 10)

4
Actiontec USB/Ethernet DSL Modem User Manual
5
Chapter 1 Introduction
Power Port
The Power port is used to connect the power cord to the Modem.
N
Warning: Do not unplug the power cord from the Modem dur-
ing the reset process. Doing so may result in permanent damage
to the Modem.
Technical Support
Self Help
To obtain answers to DSL configuration questions, visit the Qwest DSL Actiontec
support page at this address:
http://www.qwest.com/internethelp/
Basic Setup Support
If unable to access the Internet, look at the Internet light on the front of the
DSL Modem. If the light is solid green, call the ISP immediately. If it is not solid
green, call Qwest at 1-800-247-7285.
Other Problems
Contact the
ISP if experiencing problems with:
s DHCP addressing configuration
s
Static IP addressing configuration
s
Transparent bridging configuration
Contact Qwest at 1-800-247-728 5 for:
s DSL service outage support and repair
s DSL service installation support
☞ Note: Before attempting any of the above, make sure access to
the Internet is available.