Night Guard Home Surveillance System C3-RS-665 - Manual (Page 9)

9
damage to the alarm and parking relay will result.
BLACK WIRE — SYSTEM GRO UND –
This is the main ground connection of the alarm module. Make this
connection to a solid section of the vehicle frame. Do not connect this
wire to any existing ground wires supplied by the factory wire loom,
make the connection to the vehicle’s frame directly.
BROWN WIRE – (+) 2A SIREN OUTPUT –
This wire is provides power to the supplied siren. Connect the Brown
wire to the Red wire of the siren. Connect the Black wire of the siren to
a stable chassis ground.
RED WIRE — SYSTEM POWER (+12V CONSTANT) —
The RED wire supplies power to the system. Connect this wire to a
stable constant +12 volt source.
H8.2 PIN WHITE CONNECTOR (THE LED STATUS INDICATOR):
The led indicator status should be mounted in a highly visible area such
as top of the dashboard, on top of the shifter console or on the dashboard
face. Leave at least 6mm space behind the mounting location for LED
housing. Once a suitable location is chosen, drill a 6mm hole. Run the
LED wires through the hole then press the 2 pin LED housing into place.
Route the LED wires to the control module.
H4. Black 4-PIN CONNECTOR: WINDSHIELD MOUNT ANTENNA
The RF Antenna/Receiver Red connector is to be plugged in the Black
4-pin port on the main unit. The connector is to be plugged into the RF
Antenna/ Receiver plug. Mount the antenna/receiver with provided double
sided tape to center of windshield above rear view mirror, route the
antenna lead along the windshield pillar under the vehicle’s interior
windshield molding. Be sure to avoid mounting the antenna directly
behind the metallic tinted portion of the windshield.
H6. 4 PIN ORANGE CONNECTOR FOR 2 STAGE IMPACT SENSOR
1. Green Wire / Warn Away Input
2. Blue Wire / Instant Ground Trigger
3. Black Wire / Negative
4. Red Wire / + 12Volts
H7: 16-PIN MOLEX WHITE CONNECTOR WIRE HARNESS: