Night Guard Home Surveillance System C3-RS-665 - Manual (Page 24)

24
this setting.
4. Once you complete step 3, you can program “RPM Learning Mode” as
follows:
RPM LEARNING:
While the system is in Start Feature “D” programming mode,
1. Press and release the transmitter
button once, [1] LED flash, [1]
siren chirp indicating you are in features “RPM Learning mode”.
2. Start the vehicle with the key. (While the engine is running, the parking
& LED will flash, If not, please check tachometer White/Red wire
connection.
3. Press and hold the valet switch for 2 seconds until a long chirp and the
LED light is constant for two seconds. The RPM signal is learned.
4. Once you complete step 3, you can adjust and test “Check Level” as
below:
CHECK LEVEL PROGRAMMING: (TEST & ADJUST)
While the system is in Start Feature “D” programming mode,
1. Press the
button on the transmitter to start the vehicle.
2. If everything goes well:
a. Press the
button on the transmitter to stop engine running. You
have completed this programming successfully.
b. Press button on the transmitter to exit the program mode. There will
be 3 long chirps & 3 parking light flashes for confirmation.
3. If the crank time is too long, (starter will crank while the engine is
running):
a. Press the button on the transmitter to stop engine running.
Press button on the transmitter to set proper “Check Level” to
Low position. [1] LED flash, &
[1] Siren chirp will confirm this setting
b. Repeat the step1 – 4 if necessary.
4. If the crank time is too short, (Engine not running, after the starter stops
cranking):
a. Press the button on the transmitter to stop engine from running.
Press button on the transmitter to set proper “ Check Level ” to
High position. [2] LED flash, [2] siren to confirm this setting
b. Repeat the step1 – 4 if necessary.