Night Guard Home Surveillance System C3-RS-665 - Manual (Page 19)

19
2. Within 15 seconds, push the Valet switch 2 times. (Holding down on
the 2nd push) until you hear a long chirp. The transmitter is ready to
program.
Program:
1. Press the button on the transmitter until the siren responds with a
confirming chirp, the first transmitter is now programmed.
2. Press the button on the second transmitter until the siren responds
with a confirming chirp, the second transmitter is now programmed.
3. Apply the same procedure to program 3rd and 4th.
Exit: Turn Ignition to ‘OFF’ position, or leave it for 15 seconds. A 3 long
chirps & 3 parking light flashes will confirm exit.
FEATURE PROGRAMMING:
FEATURE “A” PROGRAMMING:
1. Turn the Ignition ‘switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 3 times (holding in on the 3rd push) until one
chirp with a long chirp is heard, then release the valet switch. You
are now in Alarm feature ‘A’ programming mode.
3. Press and release the transmitter button corresponding to the feature
you want to program. (See chart on next page)
The siren chirps and LED pulse will indicate new setting.
The factory default settings are always [1] LED flash, [1] siren chirp.
4. Depress the transmitter button to change the feature. Simply
keep re-depressing the transmitter button again until the module
advances to your desired setting.
a. In this case, Press the button again, the module will advance
to [2] LED flash, [2] horn chirp.
b. Press the button again; the module will advance to [3] LED
flash, [3] horn chirps etc.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulses
Three Chirps /
LED three
pulses
Four Chirps /
LED four
pulses
1
Active arming
Passive arming
without passive
door locking Passive arming
with passive
door locking
2 Automatic Rearm
off Automatic Rearm
on
3
Instant Door Ajar
error chirp
45 seconds delay
Door Ajar error
chirp.