Night Guard Home Surveillance System C3-RS-665 - Manual (Page 27)

27
3. Press the + button on the transmitter together for 6
seconds. There will be a six confirmation chirps with 3 long chirps
to confirm the system “Alarm Feature A, B Programming all
returns to factory default setting.
RETURN TO START FEATURE FACTORY DEFAULT SETTING:
Press the
button first, within 3 second, then press + button
on the transmitter together for 6 seconds. There will be six confirmation
chirps with 3 long chirps and three parking light flashes to confirming the
system “Start Feature C & D Programming” all return to their factory
default setting.
Exit: Turn the ignition switch “ON” or leave it for 15 seconds. 3 long chirps
& 3 parking light flashes will confirm exit.
SHUT DOWN DIAGNOSTICS :
The unit has the ability to report the cause of the last shutdown of the
remote start system.
Enter:
1. Turn the Ignition ‘switch to ‘ON position.
2. Press the
button on the transmitter.
3. The LED will now report the last system shutdown by flashing for one
minute in the following grouped patterns:
LED
Flashes
Shutdown Mode
1
(-) Safety Shutdown input
(Hood)
1. Close the hood.
2. Check H7/4 White/ Black wire
connection.
2
(+) Safety Shutdown input
(Brake) or
Neutral Safety Switch input
fail.
1. Check H7/3 White/ Violet wire
connection.
2. Move the Enable Toggle Switch to
“ON” position. (If installed.)
3. Move the gear selector to “Park”/
“NEUTRAL” position.
4. Check H8/11 Black/White wire
connection.
3
No RPM or
Low Voltage.
Tachometer Checking Type:
Check
H7/10 White/Red wire connection
Voltage Checking Type:
Program the “CHECK LEVEL” from
“Hi Check Level” to “Low Check Level”
5 Over-rev
6 System timed out
7 Transmitter
8
Tach. Signal has not been
learned
Re-learning the RPM
(Start Feature
D – 2 )
TESTING YOUR INSTALLATION: