Night Guard Home Surveillance System C3-RS-665 - Manual (Page 12)

12
Forth Channel Output (-)
(See Alarm Feature A- 6 Programming)
Negative output provided for forth channel operation.
PINK WIRE – (-) 200ma PROGRAMMING OUTPUT
(See Alarm Feature C - 3 Programming)
2 STEPS UNLOCK OUTPUT (Factory Default Setting) —
The 2 step unlock feature will work for the most fully electronic door lock
circuit. The vehicle must have an electronic door lock switch (not the
lock knob or key switch), which locks and unlocks all of vehicle’s doors.
When wired for this feature, pressing the disarm (or unlock) button one
time will disarm the alarm and unlock the driver’s door only. If you press
the disarm (or unlock) button two times within 3 seconds, the alarm will
disarm and all doors will unlock.
FACTORY SECURITY DISARM SIGNAL OUTPUT –
(See Alarm Feature C- 3 Programming)
This wire is designed to disarm a factory installed security system. This
wire sends a negative (-) 1 second pulse upon a remote start and
remote door unlocking. Some factory systems must be disarmed to
allow remote starting. In most cases, this wire may be connected
directly to the factory alarm disarm wire.
SENSOR BY-PASS OUTPUT–
(See Alarm Feature C - 3 Programming)
This wire is used for a by-pass module. This wire will supply an output
at all times the remote start is operating plus an additional 3 seconds
after the remote start unit turn off.
In some cases a vehicle may require a timed pulsed output
or key sense wire. If needed, program the Sensor by-pass to 20
seconds.
GRAY WIRE – (-) 200ma PROGRAMMING OUTPUT
(See Feature B - 7 Programming)
CHANNEL 2 Output (Factory Default Setting)–
This will become a 1 second pulse ground by activate channel 2 on
transmitter for two seconds. The current capacity of this wire is 200 mA.
This feature allows you to remote control trunk release or other electric
device.