Night Guard Home Surveillance System C3-RS-665 - Manual (Page 22)

22
FEATURE “C” PROGRAMMING:
1. Turn the Ignition ‘switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 7 times (holding in on the 7th push) until three
chirps with a long chirp is heard then release the valet switch. You are
now in the Start feature ‘C’ programming mode.
Press and release the transmitter button corresponding to the feature you
want to program.
Exit: Turn Ignition to ‘ON’ position, or leave it for 15 seconds.
3 long chirps & 3 parking light flashes will confirm exit.
NOTE: Before an attempt to remote start, the unit must be programmed for a system
type, Tachometer Check, Voltage Check or Timer Check.
If none of the check types have been programmed, The Remote start will have not
functioned properly.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse Three Chirps /
LED three pulse Four Chirps /
LED four pulse
1 + Gasoline Engine
Diesel Engine
without
Wait-To-Start Light
10 seconds
warm-up timer
Diesel Engine
without
Wait-To-Start
Light
15 seconds
warm-up timer Diesel Engine
without
Wait-To-Start
Light
20 seconds
warm-up timer
2
Factory alarm
disarm with
channel 2 on
Without this feature
3 +
H7/12 Pink Wire =
Two step door
unlock output H7/12 Pink Wire =
Factory Security
Disarm Signal
Output
H7/12 Pink Wire =
Start Status
Output
(Shock Sensor
Bypass)
H7/12 Pink
Wire = Start
Status Output
(Shock Sensor
Bypass 20
SEC)
4
Constant parking
light output upon
Remote Start Flashing parking
light output upon
Remote Start
5 20 minutes run time
30 minutes run
time 10 minutes run
time 5 minutes run
time
6
Door lock before
start Door lock after
shut-down
Door lock before
start and Door
lock after
shut-down
Without this
feature
7 +
Press button =
Activate Remote
Start.
Press -
button =
Activate Remote
Start.
8 +
AUTOMATIC
TRANSMISSION