Canon VB-C60 - Manual (Page 58)

2-16
Step 4 Install the Camera
Installing in the upright position
Installing on a Flat Surface
Install the rubber feet. Use the camera by placing it on a flat, stable surface.
Using a Tripod
Screw holes are provided at the bottom of the camera for installing a tripod.
Note
For this camera, the image position is set by assuming on-the ceiling installation. To reverse
the video upside down, change the direction under "Mounting Method" in the "Camera" setting
group on the Setting Page. See "Installation Conditions" ( Operation Guide).
Note
Be sure to use a tripod whose mounting screws are shorter than 5.5 mm. If a tripod whose
mounting screws are 5.5 mm or longer is used, the camera may be damaged. Also, use a
tripod base with a diameter of 30 mm or more.
30 mm
(1.18 inch)
or wider
5.5 mm
(0.22 inch)
or shorter
Tripod
mounting
screw