Canon VB-C60 - Manual (Page 57)

2-15
Init
ial S
e
tting and
Ins
ta
llati
o
n
of Cam
e
ra
Step 4 Install the Camera
Note on Use before Installing the Camera
Be sure to install the camera after setting the IP address ( P. 2-10).
Note
The camera will stop issuing IP address assignment requests 20 minutes after its power is
turned on and the detection of VB Initial Setting Tool will be disabled. Before installing the
camera, set the IP address and check the operation by referring to "Perform Initial Setting
of the Camera" ( P. 2-10).
The unique MAC address of this camera is specified at the bottom of the camera
( P. 1-20). It is recommended to write down the MAC address before installing the
camera.
Note
For installation or inspection of the VB-C60, consult/request the store where you
purchased the product.
• Wire the VB-C60 power supply, network, or other cables safely and securely
according to the relevant regulations such as technical standards for electrical
installations.
• When installing the VB-C60, select a ceiling surface, etc., capable of
withstanding the total weight of the camera and all options used (Recessed
Mounting Kit), provide sufficient reinforcements and use the bundled safety
wire if necessary.
• To prevent injuries and equipment damage due to falling items, periodically
check the brackets and screws for rusting and loosening.
• Installation in a place subject to significant vibration is not recommended,
because it may cause the equipment to malfunction.
• Do not hold the camera head when carrying the network camera.
• Do not install the VB-C60 on an unstable or inclined surface.
Malfunction may result.