Canon VB-C60 - Manual (Page 53)

2-11
Step 3 Perform Initial Setting of the Camera
Init
ial S
e
tting and
Ins
ta
llati
o
n
of Cam
e
ra
3. Enter the user name "root" and default password "VB-C60," and then enter the IP address and
subnet mask you want to set.
If the default gateway is not set, clear the [Enter a default gateway address] check box. When
the setting is complete, click [OK].
4. The progress of setting is shown in a window.
Note
There may be cautionary information that should be heeded depending on your operating
environment. See "Notes on Operating Environment" ( P. 1-13) before you perform initial
setting.
Tip
The factory setting Administrator password is "VB-C60". Be sure to change the password
for security reasons. See "Administrator Password" ( Operation Guide).
The MAC address of this camera is specified at the bottom of the camera ( P. 1-20).
The factory setting IP address is 192.168.100.1. Set a proper IP address according to the
environment in which the camera is used.
For the IP address, subnet mask and gateway address to be set, contact your Network
Administrator.