Brother QL-500A - Manual (Page 62)

APPENDIX
58 Maintenance
4
Thread the end ( ) of the Cleaning Sheet into the slot
immediately before the cutter.
5
After the Cleaning Sheet is inserted in the slot, peel off
section (
) of the sheet.
6
Turn on the QL-500/550.
7
Press and hold the FEED button for at least one second.
The roller rotates for 10 cm.
8
The adhesive surface of the Cleaning Sheet removes any dirt and lint from the roller,
and cleaning is then completed. A Cleaning Sheet can only be used once.
• Do not peel off section ( ) of the sheet.
• Make sure that the printed surface of the Cleaning Sheet is
facing up.
1
1
2
• The length of the Cleaning Sheet is 8.5 cm.
• Pressing the FEED button for less than one
second makes the roller rotate for 8 mm only.