Brother PT-9700PC - Manual (Page 31)

30
■ For network interface cable users
(Manual network configuration)
9
For Mac OS
®
X 10.3.9
Click [Add] and choose IP Printing at the
top of the screen.
Enter the IP address of the printer into the
Printer Address box. Choose “PT-
9800PCN” from the list and click [Add]
again to add the printer to the “Printer
Setup Utility”.
For Mac OS
®
X 10.4.x - 10.6
Click [Add] and choose IP Printer / IP at
the top of the screen.
Enter the IP address of the printer into the
Address box. Choose “Brother PT-
9800PCN” from the list and click [Add]
again to add the printer to the “Printer
Setup Utility”.
0
When the screen returns to “Printer List”
/ “Print & Fax” screen, check that
“Brother PT-9800PCN” is added, and
close the “Printer List” / “Print & Fax”
screen.
Now you can use the printer.
■ Installing the BRAdmin Light
configuration utility
The BRAdmin Light is a utility for initial setup
of Brother network connected devices. It can
also search for Brother products on your
network, view the status and configure basic
network settings, such as IP address.
For more information on BRAdmin Light, visit
us at http://solutions.brother.com/
1
Double click “BRAdmin Light.pkg” in the
“Mac OS X” folder.
The BRAdmin Light Installer starts up.
Follow the on-screen instructions.
2
When the installation is completed and
the message “The Software was
successfully installed.” is displayed, click
[Close].
The installation of BRAdmin Light is
completed.
Note
● When specifying the Queue Name, use
the value BRNxxxxxxxxxxxx at where
xxxxxxxxxxxx is the Ethernet address.
Note
● For details on software, see the P-touch
Editor Help.
Note
● If you are using Personal Firewall
software, BRAdmin Light may fail to
detect the unconfigured device. In that
case, disable your Personal Firewall
software, try BRAdmin Light again. Re-
start your Personal Firewall software after
the address information is set.