Brother HL 3070CW - Manual (Page 53)

Wireless configuration using SES/WPS or AOSS from the control panel (For HL-3070CW)
43
6
g If the LCD shows Connected, the machine has successfully connected to your access point/router. You
can now use your machine in a wireless network.
If the LCD shows Connection Error, a session overlap has been detected. The machine has
detected more than one access point/router on your network with the SecureEasySetup mode, the
Wi-Fi Protected Setup mode or AOSS™ mode enabled. Make sure that only one access point/router has
the SecureEasySetup mode, the Wi-Fi Protected Setup mode or the AOSS™ mode enabled and try
starting from a again.
If the LCD shows No Access Point, the machine has not detected your access point/router on your
network with the SecureEasySetup mode, the Wi-Fi Protected Setup mode or AOSS™ mode enabled.
Move the machine closer to your access point/router and try starting from a again.
If the LCD shows Connection Fail, the machine has not successfully connected to your access
point/router. Try starting from a again. If the same message is indicated again, reset the print server
back to its factory default settings and try again. (For resetting, see Reset the network settings to the
factory default on page 69.)
LCD messages when using the SES/WPS/AOSS control panel menu
LCD shows Connection status Action
Setting WLAN Searching or accessing the access point,
and downloading settings from the access
point
-
Connecting SES
Connecting WPS
Connecting AOSS
Connecting the access point
-
Connected Connection succeeded. -
Connection Error Session overlap has been detected. Check that only one router or access
point has the SecureEasySetup mode,
the Wi-Fi Protected Setup mode or
AOSS™ mode enabled and try starting
from a again.
No Access Point The access point detection failed. 1 Move the machine closer to your
access point/router and try starting
from step a again.
2 If the same message continues,
reset the print server back to its
factory default settings and try
again.
Connection Fail Connection failed. 1 Try starting from a again.
2 If the same message continues,
reset the print server back to its
factory default settings and try
again.