Brother HL 3070CW - Manual (Page 152)

Appendix
142
B
Network Wired LAN TCP/IP IP Boot
Tries 0 to 32767
3*
APIPA On* , Off
IPv6 On , Off*
Ethernet - Auto* , 100B-FD , 100B-HD , 10B-FD , 10B-
HD
Set to Default - OK?
Wired Enable - On*, Off
WLAN TCP/IP Boot Method Auto* , Static , RARP , BOOTP , DHCP
IP Address
[000-255] . [000-255] . [000-255] . [000-
255]
[000-000] . [000-000] . [000-000] . [000-
000]*
Subnet Mask [000-255] . [000-255] . [000-255] . [000-
255]
[000-000] . [000-000] . [000-000] . [000-
000]*
Gateway [000-255] . [000-255] . [000-255] . [000-
255]
[000-000] . [000-000] . [000-000] . [000-
000]*
IP Boot
Tries 0 to 32767
3*
APIPA On* , Off
IPv6 On , Off*
SES/WPS/AOSS - See Wireless configuration using SES/WPS or
AOSS from the control panel (For HL-
3070CW) in Chapter 6.
WPS w/PIN Code - See Wireless configuration using the PIN
Method of Wi-Fi Protected Setup (For HL-
3070CW) in Chapter 7.
WLAN Status Status See Status on page 65.
Signal See Signal on page 66.
Channel See Channel on page 66.
Speed See Speed on page 67.
SSID See SSID on page 67.
Comm. Mode See Comm. Mode on page 68.
Set to Default - OK?
WLAN Enable - On , Off*
Factory
Reset - - Restart Printer?
Level one Level two Level three Level four Options