Brother HL-3140CW - Manual (Page 26)

Configuring your machine for a wireless network (For HL-3140CW, HL-3150CDW and HL-3170CDW)
20
3
Configuring your machine when the SSID is not broadcast
3
a Before configuring your machine, we recommend you write down your wireless network settings. You
will need this information before you continue with the configuration.
Check and record the current wireless network settings.
1 TKIP is supported for WPA-PSK only.
For example:
3
NOTE
If your router uses WEP encryption, enter the key used as the first WEP key. Your Brother machine
supports the use of the first WEP key only.
b Press a or b to choose Network.
Press OK.
c
Press a or b to choose WLAN.
Press OK.
d
Press a or b to choose Setup Wizard.
Press OK.
e
When WLAN Enable? is displayed, press a to accept.
This will start the wireless setup wizard.
To cancel, press Cancel.
f The machine will search for your network and display a list of available SSIDs.
Choose using a or b.
Press OK.
Network name: (SSID)
Communication Mode Authentication method Encryption mode Network key
Infrastructure Open system NONE —
WEP
Shared key WEP
WPA/WPA2-PSK AES
TKIP 1
Network name: (SSID)
HELLO
Communication Mode Authentication method Encryption mode Network key
Infrastructure WPA2-PSK AES 12345678