Brother MFC-L8600CDW - Manual (Page 123)

Troubleshooting
111
B
Error and maintenance messages
B
As with any sophisticated office product, errors may occur and supplies may be replaced. If this
happens, your machine identifies the error or required routine maintenance and displays the
appropriate message. The most common error and maintenance messages are shown in the
table.
You can correct most errors and perform routine maintenance yourself. If you need more help, the
Brother Solutions Center offers the latest FAQs and troubleshooting tips:
Visit http://solutions.brother.com/.
Using non-Brother supplies may affect the print quality, hardware performance, and machine
reliability.
NOTE
The Touchscreen names are as follows.
• Multi-purpose tray: MP Tray
• Standard paper tray: Tray1
• Optional lower tray: Tray2
Error Message Cause Action
2-sided Disabled The back cover of the machine
is not closed completely. Close the back cover of the machine until it
locks into the closed position.
2-sided Disabled
Reload paper,
then press
[Retry].
Although the size of paper in
the paper tray matches the
paper size that was selected
from the control panel or printer
driver, the machine has
stopped printing when it
encountered an additional,
different size of paper in the
tray. Make sure the paper tray contains only the size
of paper you select in either the control panel or
printer driver, then press Color Start or
Black Start.
The paper tray was pulled out
before the machine completed
printing on both sides of the
paper. Reinstall the paper tray and press Color
Start or Black Start.
Access Denied The function you want to use is
restricted by Secure Function
Lock. Call your administrator to check your Secure
Function Lock Settings.
Access Error The device was removed from
the USB direct interface while
the data was processing.
Press . Reinsert the device and try to print
with Direct Print.
Belt End Soon The belt unit is near the end of
its life. Buy a new belt unit before you get a Replace
Belt message.