Brother TD-4100N - Manual (Page 21)

Troubleshooting
16
6
I have checked and tried all
of the above, but still cannot
complete the wireless
configuration. Is there
anything else I can do? wireless Use [Communication settings] in the Printer Setting Tool.
Is your Brother printer
correctly connected to the
WLAN access point/router? wireless If the STATUS indicator is lit, the network is correctly connected. If the
STATUS indicator is blinking, the network is not connected correctly, and the
wireless network setup must be reconfigured.
The Brother printer is not found on the network during the printer installation.
Question Interface Solution
Are you using security
software? wired/
wireless  Confirm your settings in the installer dialog box.
 Allow access when the security software alert message appears during
the printer installation.
Is your Brother printer
placed too far from the
WLAN access point/router? wireless Place your Brother printer within about 3.3 feet (1 meter) from the WLAN
access point/router when you configure the wireless network settings.
Are there any obstructions
(walls or furniture, for
example) between your
printer and the WLAN
access point/router? wireless Move your Brother printer to an obstruction-free area, or closer to the WLAN
access point/router.
Is there a wireless
computer, Bluetooth
supported device,
microwave oven or digital
cordless phone near the
Brother printer or the WLAN
access point/router? wireless Move all the devices away from Brother printer or WLAN access
point/router.
I cannot complete the wireless network setup configuration. (TD-2120N/2130N only) (continued)
Question Interface Solution