Brother HL-3075CW - Manual (Page 141)

Appendix
131
B
Network Wired LAN TCP/IP IP Boot
Tries 0 to 32767
3*
APIPA On* , Off
IPv6 On , Off*
Ethernet - Auto* , 100B-FD , 100B-HD , 10B-FD , 10B-
HD
Set to Default - OK?
Wired Enable - On*, Off
WLAN TCP/IP Boot Method Auto* , Static , RARP , BOOTP , DHCP
IP Address
[000-255] . [000-255] . [000-255] . [000-
255]
[000-000] . [000-000] . [000-000] . [000-
000]*
Subnet Mask [000-255] . [000-255] . [000-255] . [000-
255]
[000-000] . [000-000] . [000-000] . [000-
000]*
Gateway [000-255] . [000-255] . [000-255] . [000-
255]
[000-000] . [000-000] . [000-000] . [000-
000]*
IP Boot
Tries 0 to 32767
3*
APIPA On* , Off
IPv6 On , Off*
SES/WPS/AOSS - See Wireless configuration using WPS or
AOSS from the control panel (For HL-
3075CW) in Chapter 6.
WPS w/PIN Code - See Wireless configuration using the PIN
Method of Wi-Fi Protected Setup (For HL-
3075CW) in Chapter 7.
WLAN Status Status See Status on page 55.
Signal See Signal on page 56.
Channel See Channel on page 56.
Speed See Speed on page 57.
SSID See SSID on page 57.
Comm. Mode See Comm. Mode on page 58.
Set to Default - OK?
WLAN Enable - On , Off*
Factory
Reset - - Restart Printer?
Level one Level two Level three Level four Options