Brother CM100DM - Manual (Page 32)

30
■ Editing and Cutting the Second Pattern
Piece
a Select and edit the second pattern piece, and
then touch the “OK” key.
For details on editing the pattern, follow steps f - h
(page 29) in “Selecting and Editing the First Pattern
Piece”.
a Touch to return to the pattern category
selection screen for selecting another pattern.
b Follow the procedures described in “Loading
the Mat” (page 20) and “Cutting” (page 21) to
load the material to be used for the second
pattern piece and cut it out.
X When cutting is finished, a message appears.
c After all pattern pieces have been cut out,
touch the “Finish” key.
X The draw/cut selection screen appears again.
■ Unloading the Mat
Peel from the mat the pattern piece that was cut out.
For details on peeling the material from the mat, see
“Unloading the Mat” on page 21.
a