Brother CM100DM - Manual (Page 28)

26
■ Selecting and Editing the Second
Pattern
a Touch the “Add” key in the pattern layout
screen.
X The pattern category selection screen appears.
• Press to cancel the pattern selection, and
then select the pattern again.
b Select the category for the pattern to be cut
out.
a Touch to return to the previous screen.
c Select the second pattern to be used.
d Edit the pattern.
After editing is finished, touch the “Set” key.
• For details on the editing functions, see “Pattern
Editing Functions” on page 33.
e Check the pattern arrangement.
The two patterns that will be cut out appear in the
pattern layout screen. After checking the arrangement,
touch the “OK” key.
• From this screen, an individual pattern can be
edited, moved or deleted. For details on the
functions that can be used in the pattern layout
screen, see “Layout Editing Functions” on
page 35.
• By using the auto layout function, the
arrangement of the patterns can easily be
adjusted. For details, see “Auto Layout
Functions” on page 38.
X The draw/cut selection screen appears.
Note
• Depending on the pattern type and material to
be cut, the patterns may not be cleanly cut if
their spacing is too small. In that case,
rearrange the patterns to separate them.
Memo
• To move a pattern within the cutting/drawing
area, touch the pattern on the screen and drag
it to the desired position.
• To delete a pattern from the arrangement,
select the pattern in the layout editing screen,
and then use the function for deleting.
X Touch in the pattern layout screen.
a