Asus P4T533 - Manual (Page 65)

ASUS P4T533 motherboard user guide 49
No keyboard detected • Check your keyboard if properly
connected to the purple PS/2
connector on the rear panel.
• See section “1.4 Identifying the
motherboard components” for the
location of the connector.
No floppy disk detected • Make sure you have connected a
floppy disk to the floppy disk
connector on the motherboard.
• See section “2.8 Connectors.”
No IDE hard disk detected • Make sure you have connected an
IDE hard disk drive to the one of the
IDE connectors on the motherboard.
• See section “2.8 Connectors.”
• If you have connected the IDE
device to the optional onboard IDE/
RAID controller connector(s), then
ignore this message.
CPU temperature too high • Check CPU fan if working properly.
CPU fan failed • Check the CPU fan and make sure
it turns on after you applied power
to the system.
CPU voltage out of range • Check your power supply and
make sure it is not defective.
• Call ASUS technical support for
assistance. See the “ASUS contact
information” on page viii.
System completed Power-On Self Test • No action required
Computer now booting from operating • No action required
system
POST Message Action
You may disable the ASUS POST Reporter in the BIOS setup. See
section “4.4.2 I/O Device Configuration”.