beautypg.com

1 installing the hard disks, 2 enter fasttrak133 bios and fastbuild utility – Asus P4T533 User Manual

Page 123

background image

ASUS P4T533 motherboard user guide

103

5.10.1 Installing the Hard Disks

The RAID 0 setting allows users to reformat two hard disks with the same
new OS simultaneously. RAID 1 arrays can use a pre-existing hard disk
along with a blank hard disk, or two new hard disks.

FastBuild (tm) Utility 1.31 (c) 1996-2000 Promise Technology, Inc.

Auto Setup . . . . . . . . . .

[ 1 ]

View Drive Assignments . . . . [ 2 ]

[ 2 ]

View Array . . . . . . . . . . [ 3 ]

[ 3 ]

Delete Array . . . . . . . . . [ 4 ]

[ 4 ]

Rebuild Array. . . . . . . . . [ 5 ]

[ 5 ]

Controller Configuration . . . [ 6 ]

[ 6 ]

Press 1..6 to select Option [ESC] Exit

[ Main Menu ]

[ Keys Available ]

1. Boot-up your computer once more. If this is the first time you have booted

with two hard disks correctly installed, then MBFastTrak133™ “Lite” BIOS
scans the IDE drives and displays this screen:

2

.

Press keys to display the FastBuild™ Utility Main Menu:

1. Install the first and second hard disk into the hard disk bays of your system.

Connect each hard disk drive with a separate UltraDMA/100 cable, one
to the PRI_RAID connector, and the other to the SEC_RAID connector.
(Do not connect any other types of IDE devices to the Promise IDE
connectors; they support hard disk drive devices only.)

2. Connect the power cables to the hard disks.
3. Make sure the RAID_SW jumper is set to [1-2] and, if available, ensure

the BIOS settings in the Advanced PCI Configuration sub-menu are set
to enable RAID arrays: “SCSI/ATA100 Boot Sequence” field should be
set to [ATA100/SCSI] and the “Load Onboard ATA BIOS” field should be
set to [Auto].

4. Boot-up the PC.

5.10.2 Enter FastTrak133 BIOS and FastBuild Utility

If using an existing HDD and one new HDD to make a new RAID array,
make a back-up of all data before starting the configuration.