Asus P4T533 User Manual
Page 51
ASUS P4T533 motherboard user guide
37
11. Floppy disk drive connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the
floppy drive. (Pin 5 is removed to prevent incorrect insertion when using
ribbon cables with pin 5 plug).
P4T533
®
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
P4T533 Floppy Disk Drive Connector
PIN 1
FLOPPY
12. Power, CPU and Chassis Fan Connectors (Three 3-pin PWR_,
CPU_, CHA_FAN)
The two fan connectors support cooling fans of 350mA (4.2 Watts) or a
total of 1A (12W) at +12V. Orient the fans so that the heat sink fins allow
air flow to go across the onboard heat sinks instead of the expansion
slots. The fan wiring and plug may vary depending on the fan
manufacturer. Connect the fan cable to the connector matching the black
wire to the ground pin.
P4T533
®
P4T533 12-Volt Fan Connectors
CPU_FAN
PWRFAN
CH_FAN
GND
Rotation
+12V
GND
Rotation
+12V
GND
Rotation
+12V
Do not forget to connect the fan cables to the fan connectors. Lack of
sufficient air flow within the system may damage the motherboard
components. These are not jumpers! DO NOT place jumper caps on
the fan connectors!