Aussie Bushman - Manual (Page 36)

Remove and wash the Flavor Activator™ in order to keep it
clean. Burning off the residue after each cooking will make
cleaning easier. Clean with soap and water.
· Always turn the LP gas cylinder valve “Off” when
not in use. Allow grill to cool before handling parts
or cleaning.
· Empty the Grease cup after each cooking session so
excessive grease does not accumulate.
Failure to remove grease may result in grease
dripping onto the cart and/or a grease fire in the cup.
· Never light the LP gas grill without the grease cup in
place.
· Before each use, remove all grease from your Grease Cup.
· Make sure Grease Cup is in place before each grilling
session.
· Failure to remove grease from the Grease Cup may result
in grease dripping onto the cart.
· Always turn off the LP gas cylinder at the LP
cylinder valve when not in use. Allow grill to cool
before handling parts or cleaning.
How to Clean the Grill Body
1) Remove Cooking Grid, Flavor Activator™, and Burner
before full cleaning.
2) Remove excess grease and/or fat from the grill Bowl
with a soft plastic or wooden scraper. Never use steel
wool or other abrasive cleaning product on porcelain
coated surfaces.
3) For further cleaning, use hot soapy water and a cloth, or
nylon-bristled brush only. Do not immerse the gas
controls or manifold in water. Make sure all water is
removed from Burner.
4) When finished cleaning, replace Burner, Flavor
Activator™ and Cooking Grid according to Steps 6, 7, 18,
and 21 in the Assembly Instructions.
5) Check burner operation after reassembly.
· Always turn off the LP gas cylinder at the LP
cylinder valve when not in use. Allow grill to cool
before handling parts or cleaning.
· Do not use aerosols or store flammable liquids or
materials near this gas grill.
Periodically check and tighten all nuts, bolts, and screws.
· Never store an LP gas cylinder indoors (empty or
filled). If storing the gas grill indoors, disconnect
the LP gas cylinder and store it outdoors out of the
reach of children.
· Never leave an LP gas cylinder inside a vehicle
which may become overheated by the sun.
· Never store a spare or disconnected LP gas
cylinder under or near the LP gas grill.
· Always turn off the gas cylinder when not in use.
Allow grill to cool before handling parts or
cleaning.
· Even though your LP gas cylinder may appear to be
empty, gas may still be present and the cylinder
should be transported and stored accordingly.
· Store your LP gas grill in a cool dry place .
· Disconnect LP gas cylinder from grill and store outside, in
a dry, well-ventilated area, away from any sources of heat
or ignition. Re-cap LP cylinder valve with the Safety Cap.
· Remove Burner and wrap with aluminum foil to prevent
insects from entering the burner holes. Store wrapped
Burner on top of cooking grid.
· Before next use, remove aluminum foil and reinstall
Burner, Flavor Activator, and Cooking Grid according to
Assembly Instructions.
· Check your LP gas grill for gas leaks, deterioration, proper
assembly, and burner obstructions before using the grill
after periods of storage and/or non-use(i.e. over winter).
Flavor Activator™
Drip Cup
Cleaning the Grill Bowl
Preventive Maintenance
Storage
36