beautypg.com

Aussie Bushman User Manual

Page 16

background image

STEP 8 - Mount Igniter/ Flavor Activator Mounting Stud to Grill Bowl

16

TOOLS

•Mount Igniter to Grill Bowl : With Tightening Nut removed, Insert Igniter threaded section down

through Igniter hole ( located in center and next to and in front of Burner) of grill Bowl from inside
until Igniter is resting on bottom of Bowl. NOTE: Do not remove or loosen the adjusting nuts on
Igniter as the correct height has been preset by the factory. (See Photo 1 below)

•Position open side of Igniter Box to face Burner and secure Igniter with Tightening Nut from

underside of grill Bowl. While keeping the Ignitor Box aligned with the edge of the Burner, tighten.
(See Photo 2 below)

•Insert 6M washer onto the threaded end of each Flavor Activator Mounting Studs. Insert Flavor
Activator Mounting Stud into center hole on each side of bowl and secure with 6M nut. (See Photo 3)

(ITEM 25)

IGNITER

(ITEM 52)

FLAVOR ACTIVATOR

MOUNTING STUD

2 pcs

(ITEM 27)

6mm WASHER

2 pcs

(ITEM 9)
NUT, 6M

2 pcs

Flavor

Activator™

Mounting

Stud

Tightening Nut - Comes on

threaded post of Igniter and

should be removed before

mounting on Grill.

Photo 1

Photo 2

Photo 3

3/16”
GAP

Collector Box

Electrode

Fig 1