TOHO ELECTRONICS TTM-339 - Manual (Page 26)

- 26 -
5.8 Common parameter setting mode SET 10
SET10 Name Setting content Initial value
1 INP1 Input type setting (*2) (*3)
0 K thermocouple 11 PR40-20
0
1 J thermocouple 12 PLII
2 T thermocouple 13 Pt100
3 E thermocouple 14 JPt100
4 R thermocouple 15 0 - 10 mV DC
5 S thermocouple 16 0 - 1 V DC
6 B thermocouple 17 0 - 5 V DC
7 N thermocouple 18 1 - 5 V DC
8 U thermocouple 19 0 - 10 V DC
9 L thermocouple 20 4 - 20 mA DC
10 WRe5-26
2 FSH1 Scaling upper limit setting (*2) (*3) Current/voltage input only
FSL1 to 29999 (digit)
10000
3 FSL1 Scaling lower limit setting (*2) (*3) Current/voltage input only
-19999 to FSH1 (digit)
-10000
4 PVG1 PV compensation gain setting 0.500 to 2.000 (times) 1.000
5 PVS1 PV compensation zero setting
Thermocouple/RTD input
-999.9 to 999.9 (

C)
-999 to 999 (

C) 0
Current/voltage input
-9999 to 9999 (digit)
6 PDF1 PV filter setting 0.0 to 99.9 (seconds) 0.0
7 PDFS Special PV filter setting 0.0 to 99.9 (seconds) 0.0
8 DP1 Decimal point position
setting (*2) (*3)
Thermocouple/RTD input
0
0 Unit of 1

C
0.0 Unit of 0.1

C
Current/voltage input
0 1/digit
0.0 0.1/digit
0.00 0.01/digit
0.000 0.001/digit
0.0000 0.0001/digit
5.9 Common parameter setting mode SET 11
SET11 Name Setting content Initial value
1 BKUP Backup of a setting value (*2) (*3)
Backup begins by holding the  and  keys pressed for 2 seconds.
During the backup, “SAVE” is displayed; turn-off of the display indicates
ended backup.
2 RESET Initialization of a setting value (*2)
Initialization of the backup setting begins by holding both  and  keys
pressed for 2 seconds.
During initialization, “LoAd” is displayed and turn-off of the display
indicates ended initialization.