Sterlco Micro Series Water Temperature Control Unit - Manual (Page 3)

MICRO Series Water Temperature Control Units Page 3
Safety Considerations
MICRO Series temperature control units are designed to provide safe and reliable
operation when installed and operated within design specifications and when
following national and local safety codes.
To avoid possible personnel injury or equipment damage when installing,
operating, or maintaining this equipment, use good judgment and follow these
safe practices:
; Only PROPERLY TRAINED personnel familiar with the information
within this manual should work on this equipment.
; Follow all local SAFETY CODES.
; MICRO Series cabinets and piping are hot and are a BURN HAZARD.
; Do not operate a MICRO Series system without all outer panels installed.
Pressurized hot water leaks can cause serious injury.
; Wear SAFETY GLASSES and WORK GLOVES.
; Use care when LOADING, UNLOADING, RIGGING, or MOVING this
equipment.
; Operate this equipment within design specifications.
; OPEN, TAG, and LOCK ALL DISCONNECTS before working on
equipment. We recommend following OSHA Lock-Out/Tag-Out Standard 29
CFR 1910.147.
; Make sure the unit is properly GROUNDED before switching power on.
; When welding or brazing in or around this equipment, be sure
VENTILATION is ADEQUATE. PROTECT adjacent materials from
flame or sparks by shielding with sheet metal. An approved FIRE
EXTINGUISHER should be close at hand and ready for use if needed.
; Do not jump or bypass any electrical safety control.
; Do not restore power until all tools, test equipment, etc. have been removed
and the panels replaced.