Mounting and removal – ROTRONIC RS24T User Manual
Page 10
E(D/F)-M-RS12/24T-V1_00
Rotronic AG
Bassersdorf, Switzerland
Document code
Unit
Ventilierter Wetterschutz
Ventilated weather and radiation
shield
Instruction Manual
Document Type
Page 10 of 17
Document title
5. Mounting and removal
The protection shields, probes and mounting arms are always delivered separately.
Assemble the parts as follows:
5.1 Put the probe into the respective probe adaptor according to the design. Tighten either the
Hex screw of the adaptor ring or the set screws on the probe tube. (Depending on probe
used). Tighten the screws only as hard as necessary to hold the probe firmly. Set the
distance from the probe tip according to the design below. Note: Depending on the probe,
different adaptors are used.
a. HC2-Series Probes
b. MPH-Series Probes