ROTRONIC Dockingstation with WEB-Server - Manual (Page 9)

IN-E-DS-U4WEB-V1_14
Rotronic AG
Bassersdorf, Switzerland
Document code Unit
Docking station DS-U4WEB with web
server version 1: instruction manual Instruction Manual
Document Type
Page 9 of 15
Document title
© 2007; Rotronic AG IN-E-DS-U4WEB-V1_14
7 Other configuration settings
Either the HW4 software or the Web Server can be used to configure both the HygroLog NT data
logger and docking station. Unlike HW4, the Web Server does not generate an authenticated
configuration protocol. For this reason, using HW4 should be the preferred configuration method.
With the exception of the TCP/IP settings and other settings of the docking station internal
Ethernet module, all configuration data is retained in the HygroLog NT non-volatile memory. In
particular, no input configuration data is retained in the docking station proper. Therefore, it is
important to observe the following:
• Prior to configuring the data logger and docking station with the HW4 software, we strongly
recommend enabling HW4 to generate and save protocols (see below). After using Device
Manager in HW4 to configure the data logger and docking station, print the configuration
protocol for your records. This protocol includes information that will eventually be useful
such as serial number and firmware version of the data logger, serial number and firmware
version of the docking station as well as detailed configuration settings (logger and docking
station).
• Search for the data logger with HW4 and use Device Manager to configure both the data
logger and any available probe or logical input of the docking station as required by the
intended application.