Figure 3.11: receiver network configuration menu – Avocent ECMS2000U User Manual
Page 33
22 Avocent Emerge ECMS2000U Extender Installer/User Guide
5.
Choose Receiver Network Config. The Receiver Network Configuration Menu will appear.
The current network settings are visible here.
Figure 3.11: Receiver Network Configuration Menu
NOTE: The Reset option in the Receiver Network Configuration Menu applies only to network settings.
6.
Choose Receiver IP Address.
7.
Type a valid IP address. Press
Enter
to return to the Receiver Network Configuration Menu.
8.
Choose Receiver Netmask.
9.
Type a valid Receiver Netmask. Press
Enter
to return to the Receiver Network
Configuration Menu.
10. Choose Receiver Default Gateway.
11. Type a valid Receiver Default Gateway. Press
Enter
to return to the Receiver Network
Configuration Menu.
12. Type
0
(zero) and press
Enter
to return to the Network Configuration Menu.
13. If you made a mistake and do not wish to save the changes you made to the network settings
type
C
and press
Enter
.
14. To confirm your changes and apply those settings, type
0
(zero) and press
Enter
.
NOTE: Changes to network configurations are applied only after you exit the Network Configuration Menu
15. The Receiver will now automatically reset to apply the new network configuration. During
reset, the Receiver will drop its connection to the Transmitter. You will be automatically
returned to the Appliance Selection Menu screen. The connection will be restored.