Avocent ECMS2000U User Manual
Page 31
20 Avocent Emerge ECMS2000U Extender Installer/User Guide
19. Choose Transmitter IP Config. The Transmitter IP Config menu will appear. The old
Transmitter IP address is displayed beside menu option 1.
Figure 3.8: Transmitter Configuration Menu on the Receiver
20. Choose Transmitter IP Address. Type the new IP address for the Transmitter. Press
Enter
to
return to the Transmitter IP Configuration Menu.
21. Type
0
(zero) and press
Enter
to return to the Network Configuration Menu.
22. If you made a mistake and do not wish to save the changes you made to the network settings
type
C
and press
Enter
.
23. To confirm your changes and apply those settings type
0
(zero) and press
Enter
.
24. The Receiver will now automatically reset to apply the new network configuration. You will be
automatically returned to the Appliance Selection Menu screen. The connection to the
Transmitter will be automatically restored.
To configure network settings for the Receiver:
1.
Activate the serial menu as described in Accessing the serial menu on page 14.
2.
Choose option 1 to access the Receiver menu. If the password option is enabled, you will be
prompted for a password. See Authentication on page 24.