Figure 3.5: transmitter network configuration menu – Avocent ECMS2000U User Manual
Page 29
18 Avocent Emerge ECMS2000U Extender Installer/User Guide
5.
Choose Transmitter Network Config. The Transmitter Network Configuration Menu
will appear.
Figure 3.5: Transmitter Network Configuration Menu
6.
Choose Transmitter IP Address.
7.
Type a valid IP address. Press
Enter
to return to the Transmitter Network Configuration Menu.
8.
Choose Transmitter Netmask.
9.
Type a valid Transmitter Netmask. Press
Enter
to return to the Transmitter Network
Configuration Menu.
10. Choose Transmitter Default Gateway.
11. Type a valid Transmitter Default Gateway. Press
Enter
to return to the Transmitter Network
Configuration Menu.
12. Type
0
(zero) and press
Enter
to return to the Network Configuration Menu.
13. If you made a mistake and do not wish to save the changes you made to the network settings
type
C
and press
Enter
.
14. To confirm your changes and apply those settings type
0
(zero) and press
Enter
.
15. A system message will appear that states “Connection to the Transmitter is lost”. You will be
automatically returned to the Appliance Selection Menu screen.
16. Choose option 1 to access the Receiver menu. If the password option is enabled, you will be
prompted for a password. See Authentication on page 24.