Dwyer 4C User Manual
Page 3
Page 3
MODEL NUMBER IDENTIFICATION
GETTING STARTED
1. Install the control as described on page 4.
2. Wire your control following the instructions on page 6. Please read
the Precautions section located at the end of this manual before wiring
the control.
3. For best results when programming changes are necessary, make all
changes to the Initial Setting mode (Pages 13-14) before making changes
to the Regulation Mode (Pages 11-12) or Operation Mode (Pages 10). If
any error messages occur, check the Diagnostic Error Message Section
(Page 18) for assistance.
16C
OUTPUT 1
2 = Voltage Pulse
3 = Relay
5 = Current
6 = Linear Voltage
8C
OUTPUT 1
2 = Voltage Pulse
3 = Relay
5 = Current
6 = Linear Voltage
4C
OUTPUT 1
2 = Voltage Pulse
3 = Relay
5 = Current
6 = Linear Voltage