Badger Meter M-Series Field Verification Device - Manual (Page 10)

Page 10
8-11
Field Verification Device
M5000
Opening the Cover
1. Using a ¼ inch slotted screwdriver, remove the two top screws from the front of the amplifier.
2. Loosen the two bottom screws until the screw heads protrude above the surface of the amplifier door.
3. Open the amplifier door from top to bottom.
Connecting the Cable Harness
The individual connector wires are labeled as to where each connector is to be connected onto the internal circuit board of
the amplifier. A connection instruction label has been placed inside the amplifier for reference.
On an M5000 cable harness are following connectors:
• RS232 (4-pin connector)
• Output A (2-pin connector)
• Output B (2-pin connector)
• Output C (2-pin connector)
• Output D (2-pin connector)
• Detector Electrode (5-pin connector)
• Detector Coil (2-pin connector)
• Amplifier Electrode (5-pin connector)
• Amplifier Coil Output (2-pin connector)
• Detector Ground (alligator clip)
Figure 7: M5000 Wire Harness Connectors
Note: Refer to "M5000 Harness Connections" on page 11 for the designated circuit board connections.