Thermo Fisher Scientific CyberScan pH 1000/pH 2500 User Manual
Page 31
Instruction Manual
pH 1000/ 2500
25
12.11 Memory Input Functions and Options
The meters can store up to 16 sets of values (pH/mV/Relative mV
together with temperature). The Last-In-First-Out (LIFO) method of
the memory management is used. When the memory is full, the
value stored in the first memory location will be erased to create
space for the new input value.
1. During any measurement operation, press MI.
2.
The MEM annunciator flashes to indicate that the data has already
been stored into memory.
Memory Options
To access two MI options, press SHIFT followed by MI/OPT.
1st Option: Memory Input When Ready
The factory default setting is OFF. When turned ON, the meter
automatically stores the reading into memory when the READY
indicator is displayed.
Use
S or T key to turn on or off the MI READY option. Press YES to
confirm. Meter advances to the second option.
NOTE : To activate the MI READY option successfully,
the READY mode must be ON prior to setting MI READY
(See switching on READY mode). If not, go back to
setting the READY on before returning to this option.
2nd Option: Input Time Interval
This option allows you to input readings into the memory at a user
selected time interval (between 1 minute to 23 hours 59 minutes).
Default is “- - - -“.
To access memory input on time interval function:
1. Press
SHIFT and then MI. The first option READY appears.
2. Press
YES to proceed to the next option - time interval function.
3. Enter the desired time interval using the numeric keys followed by
YES to confirm. To cancel an entry before confirming, press NO and
re-enter value before confirming. Meter will return to the
measurement mode.
4.
To remove a previously set time interval, press the +/- key twice
before confirming.