SHIMPO DRI-series - Manual (Page 17)

17
The DRI will default to certain parameters when power is turned OFF and ON. To access the parameter settings:
1. Press the PEAK button while holding down the ON button; the small display will indicate “dSP”.
2. Each time the PEAK button is pressed, the DRI will scroll through each of the parameters.
3. Press the RESET button to exit.
See the chart below for the location of descriptions of the options within each parameter.
Parameter Settings
DESCRIPTION DISPLAY OPTIONS
Display Update Time (in seconds)
(see page 6) 0.125, 0.25, 0.5, 1, 2
Measuring Mode on, oFF
(see page 5)
Auto Power Off nonE, 3
(see page 18)
Measurement Units English, Metr ic, or Newton
(see page 5) Load Cells: Lb(oz), Kg(g), N
Torque: LbI(oZI), KgC(gC), NCM
Output Type nonE, dG, 232C
(see page 9-13)
Exter nal Control Input nonE, tArE, HoLd
(see page 14-15)
Memory Mode nonE, SinG, Cont
(see page 7)
Update time for on(1ms), oFF(display update time)
Analog Output
(see page 13)
Filter 0, 1, 2
(see page 8)