SHIMPO DT-5TP - Manual (Page 8)

Mode 5: Self T Mode 5: Self T Mode 5: Self T Mode 5: Self T Mode 5: Self Test est est est est
This mode lets you check the LED display and input
circuitry.
1. After disconnecting sensor, press
mode and data set keys for five
seconds.
2. Press increment key until
display
Specifications Specifications Specifications Specifications Specifications
Model DT-5TP (VDC)
Mode Rate Measurement
Display Range 0.0000–9.9999
0.000–99.999
0.00–999.99
0.0–9999.9
0–99999
Measuring range 10–99999 rpm (at 1p/r), 0.2–30000 rpm
(at 60p/r)
Display period 1 sec. (1 p/r input 60 rpm or over)
1–6 sec. (1 p/r input 10–60 rpm)
Display Red LED (0.56" or 14.2 mm high)
Time base Controlled by a 4.194304 MHz crystal
Accuracy ±0.008% ± 1 digit
Measuring system CPU controlled
Input no. of p/r 1–9999 (programmable)
Input signal
characteristics Sine wave–max frequency 10 KHz
Square wave–max frequency 30 KHz
Open collector–max frequency 30 KHz
Contact closure–max frequency 20 Hz
Input signal amplitude Sine wave (0.3–30 VP–P)
Square wave LO: 0–1.5 V, HI 4–30 V
Input impedance Approx. 10 k ohms
Voltage output 12 VDC ±5% (50 mA max) to power sensors
Ambient temperature 32°–113° F (0°–45° C)
Power consumption 1W
Voltage requirements 9–35 VDC
Dimensions 3.46"L x 1.88"H x 3.78"W (88L x 48H x 96W
mm), includes bezel, fit 1/8 DIN cutout
Weight 0.55 lbs (250g)
Error Codes Error Codes Error Codes Error Codes Error Codes
Display Type of Error What to Do
EE-02 Internal memory Press data set key. Interrupt power at terminals 1 and 2.
EE-03 Memory recall 1. Press data set key.
2a. Press increment key. Display should show
2b. Press data set key. Display should show
2c. Press shift key. Display should show
2d. Press mode key. Display should show
and reset to . If display goes to or and
locks up, turn power off and on again and repeat above steps.
SHIMPO INSTRUMENTS 1701 Glenlake Avenue Itasca, IL 60143 USA (630) 924-7138 Fax (630) 924-0342
shows mode 5.
3. Press mode key to test display
segments and decimal points.
4. Press mode key. The display will
show and the signal
will flash.
5. Press the data set key. The unit
is
now ready for counting.