Aastra Telecom CT9143i - Manual (Page 54)

New Features in Release 2.3
50 RN-001029-02, Release 2.3, Rev 00
IP Phone Release Notes 2.3
Configuring Preferred Line Focus via the Configuration Files
Use the following parameters to configure preferred line focus using the configuration files.
caller id If the "Switch UI Focus To Ringing Line" parameter is disabled,
the User is able to see the Caller ID when the phone switches the
focus to the ringing line.
factory default Factory default and recovery mode clears the "preferred line" and
"preferred line timeout" parameters, and the phone operates in a
non-preferred line mode.
Notes:
1. If you specify a value of “0” for the preferred line parameter, it
disables the preferred line focus feature. The phone behaves as in
previous releases.
2. If you specify a value of “0” for the preferred line timeout
parameter, the phone returns the line to the preferred line immediately.
Parameter–
preferred line
Preferred Line
(in Web UI)
Configuration Files aastra.cfg, .cfg
Aastra Web UI Basic Settings->Preferences->General
Description Specifies the preferred line to switch focus to when incoming or outgoing
calls end on the phone.
Format Integer
Default Value 1
Range 0 (none - disables the preferred line focus feature)
1 to 9
Example preferred line: 2
Parameter–
preferred line timeout
Preferred Line Timeout
(seconds)
(in Web UI)
Configuration Files aastra.cfg, .cfg
Aastra Web UI Basic Settings->Preferences->General
Description Specifies the time, in seconds, that the phone switches back to the preferred
line after a call (incoming or outgoing) ends on the phone, or after a duration
of inactivity on an active line.
Format Integer
Default Value 0 (the phone returns the line to the preferred line immediately)
Range 0 to 999
Example preferred line timeout: 30
Phone Feature Preferred Line Focus Behavior