APPLIED ENGINEERING Sonic Blaster - Manual (Page 40)

CHAPTER THREE
The “Edit” Options
Undo ( -Z)
After you’ve made a change to the file, you can select Undo to
cancel the most recent modification. The Undo command will be
followed by the most recent option you’ve selected, for example,
Undo Paste or Undo Echo . If Undo isn’t an option for the change
you’ve made, the undo command will be dimmed.
Cut ( -X)
After you’ve selected a portion of the graph, choose Cut to
remove the selection from the screen and copy it to the GS
clipboard. You can then paste it to another location on the same
file or to a different file. The selection will remain in the
clipboard until something else is pasted in to take its place or
until you quit the program.
Copy ( -C)
Choosing Copy when a portion of the file is selected will copy
the selection to the clipboard without removing the selection
from the screen.
Paste ( -V)
Selecting Paste copies the current contents of the clipboard into
file at the selection bar position. If a section of the file is selected
when you choose paste, the clipboard contents will replace the
selection. If a selection was recorded at a different rate from the
file you paste it into, the pasted selection will be played at the
rate of the file into which you paste it.
A Note about the Clipboard
The Sonic Blaster’s clipboard is a local clipboard; it can be used
only for the Sonic Blaster program. Once you quit the program,
whatever you currently have pasted to the clipboard is lost.
Ch. 3 - The "Edit" Options 31