APPLIED ENGINEERING Sonic Blaster - Manual (Page 13)

Recording and Saving Changes
To record or save changes to a file using the Sonic Blaster
software, you should install the card in slot 1, 2, or 6 and set the
Slot option to ‘Your Card.’ If the Slot option is not set to ‘Your
Card” the software will give you the error message,
“Requires
AE Sonic Blaster Card” because it cannot “see” the Sonic
Blaster card.
◊
If you’re not using slot 6, put the card in there and leave
the Slots option set to “
Your Card ”
◊
If you have an external modem connected to the GS
modem port, put it in slot 2 and toggle between the
Sonic Blaster and the modem with the Control Panel’s
Slots option.
◊
If you have an internal modem and a printer connected
to the
GS’ printer port, put it in slot 1 and toggle between
Sonic Blaster and the printer with the Control Panel’s
Slots option.
The Slots option setting will be discussed more in step 12 of the
next chapter.
RamKeeper Users
You’ll need to take your RamKeeper out of its slot during the
installation. Before beginning the installation, back up your
ROM disk and disconnect both the transformer and the battery.
You will not need to remove the RamKeeper’s connector plate.
The rest will be explained in Chapter 2.