Asus Pedestal Server TS100-E4/PI2 - Manual (Page 48)

3-6 Chapter 3: Motherboard Information
2. CPU fan pin selection (3-pin FM_CPU1, FM_CPU2)
These jumpers allow you to connect either a 3-pin or a 4-pin fan cable
plug to the CPU fan connectors (CPU_FAN1, CPU_FAN2). Set these
jumpers to pins 1-2 if you are using a 3-pin fan cable plug, or to pins
2-3 if you are using a 4-pin plug.
3. USB device wake-up (3-pin USBPW12, USBPW34)
Set these jumpers to +5V to wake up the computer from S1 sleep
mode (CPU stopped, DRAM refreshed, system running in low power
mode) using the connected USB devices. Set to +5VSB to wake up
from S4 sleep mode (no power to CPU, DRAM in slow refresh, power
supply in reduced power mode).
• The USB device wake-up feature requires a power supply that can
provide 500mA on the +5VSB lead for each USB port; otherwise, the
system would not power up.
• If you are using Windows 2000, you need to install Service Pack 4 to
wake up the system from S4 sleep mode.
• The total current consumed must NOT exceed the power supply
capability (+5VSB) whether under normal condition or in sleep mode.
P5M2-M/C_TS100-E
4
®
P5M2-M/C_TS100-E4 USB Device Wake-Up
USBPW12
(Default)
+5V +5VSB
2 3 1 2
(Default)
+5V +5VSB
2 3 1 2
USBPW34
P5M2-M/C_TS100-E
4
®
P5M2-M/C_TS100-E4 FM CPU Setting
FM_CPU2
FM_CPU1
1 2 2 3
3-pin fan 4-pin fan
(Default)
2
3
2
1
3-pin fan 4-pin fan
(Default)